Each machine has its rated power, and the laser spot welding machine is no exception. Sometimes the output power of the laser spot welding machine is not enough in the process of use. The cause of this problem needs our specific analysis to find the cause.
Based on our experience and analysis, we find that there are five main types of causes. Let's share them with you. If it is a laser spot welding machine that has just left the factory, it depends on whether the power set when it leaves the factory is too small, whether its full reflection diaphragm leaks light, and whether its resonator adjustment meets the factory indicators. If these conditions occur, the laser spot welding machine does not meet the factory standards, and the manufacturer can be required to replace it.
If the output power of those laser spot welding machines that have been used for a long time is insufficient, it depends on whether the first full reverse diaphragm is dirty again, and if so, wipe it clean; Second, check whether the resonator changes. If so, micro tune the resonator to make the output spot reach the best; Third, it depends on whether the temperature difference between the cooling water tank and the surrounding ambient temperature exceeds 5 degrees. If it exceeds 5 degrees, it should be controlled within 5 degrees; Fourth, it depends on whether the brightness of krypton lamp is enough and whether it needs to be replaced when its service life expires; Fifth, it depends on whether the position of acoustooptic crystal is different from that set at the beginning. If so, it needs to be adjusted in time.

In fact, many times, the insufficient output power is caused by improper use and operation. Reasonable use can reduce the occurrence of this kind of situation and prolong the service life of laser spot welding machine.







