Laser cutting is a high-precision mechanical equipment, which requires strict requirements in the process of use. A key component of the left and right laser cutting effect is the installation of the lens of the laser cutting machine. If this component is not installed according to the specified steps, it is easy to lead to the deviation of the cutting center or even the dislocation of the groove edge of the cutting machine. So what should we pay attention to when installing the lens of laser cutting machine?
Step 1: please clean your hands before operation. It is best to wash your hands with soap or detergent. This is a good habit for normal operation of cutting machine lens. Do not directly touch the lens with bare hands, but operate with special gloves to prevent finger prints from affecting the accuracy of the lens.
Step 2: when placing the lens, pay attention to stability to avoid falling and damaging. At the same time, pay attention to placing the convex surface of the lens flat on a stable and clean desktop. At the same time, pay attention to check that the desktop is free of sundries to avoid confusion or affect the operating environment of the lens.
Step 3: the lens of the laser cutting machine shall be protected from moisture, and the traditional blowing method shall not be used to wipe the lens, and the hot gas shall not be used to blow the lens together, so as not to damage the lens due to sudden change of heat. The lens is of high precision, and the temperature and humidity are strictly controlled to avoid affecting the lens surface protective film and optical accuracy.
Step 4: after the lens of the laser cutting machine is assembled, pay attention to the cleaning and dust removal of the lens. It is best to use a clean air spray gun instead of an ordinary spray gun.
Step 5: the lens of the cutting machine must be kept absolutely clean, and do not touch the lens surface directly by hand, and strictly prevent other non designated items from directly contacting the lens surface. In the cleaning and maintenance of the lens, professional wiping paper shall be used to gently pull from one side to the other to avoid scratching the lens surface.
