+8613682329217

Laser Engraving Machine Maintenance During Operation

Mar 21, 2022

1.The equipment casing, laser power supply and computer power supply must be well grounded. The grounding screw should be regularly checked for corrosion or looseness, and cleaned and tightened in time.

2.If the moving parts such as trolley pulley, slideway and linear guide rail are polluted or rusted, it will directly affect the processing effect. They should be cleaned regularly and coated with lubricating oil at the guide rail to prevent rust.

3.After long-term use (especially cutting), the honeycomb platform will stick to the processing waste and even block the honeycomb hole. In case of laser irradiation, it may smoke or even burn, which should be removed regularly.

4.Note that the smoke exhaust outlet and exhaust duct shall not be blocked. Check and remove the shelter at any time to keep it unblocked.

5.The cooling water shall be kept clean and replaced regularly. During processing, check whether the water level is sufficient and whether the water temperature is too high.

riselaser product show-1

Send Inquiry